|
Tools needed are drill w/#15 torx bit,fine needle nose pliers,pointed wirecutters, tape, foil, a set of small jewelers screwdriv
Date: 02/29/2004
Views: 25
|
There are 11 screws to remove including the ones from the red and blue13 pin connectors The connectors will not come out when y
Date: 02/29/2004
Views: 26
|
Carefully pull out the 8 pin plug
Date: 03/01/2004
Views: 27
|
|
Pull circuit board off There are 4 sets of connectors like the set pointed to, these are on the back of the gauges and are gripp
Date: 03/01/2004
Views: 23
|
Board removed
Date: 03/01/2004
Views: 23
|
Notice the back of the gauges where the prongs were attached to the board.
Date: 03/01/2004
Views: 22
|
|
Remove screws from front to separate the clear lens from the gauges
Date: 03/01/2004
Views: 21
|
Remove the screws from the MPH & Tach first then the gas and temp gauges. Due to one screw in the middle of the gauges hold
Date: 03/01/2004
Views: 32
|
Cut foil to fit and tape down.
Date: 03/01/2004
Views: 29
|
