|
On the 1st Generation Sebring the PCM with the Torque Management Request Sense wire is the plug closest to you, which contains p
Date: 04/12/2004
Views: 17
|
Woops, sort of fuzzy. Remove the protective tape a few inches down the bundle of wires, cut very carefully. I used a pair of s
Date: 04/12/2004
Views: 13
|
The wire you're looking for is Yellow and Dark Green, also Pin #63 on the plug.
Date: 04/12/2004
Views: 13
|
|
Cut the wire, leaving enough slack to strip and crimp on a male and female connector, in case you want to remove your switch or
Date: 04/12/2004
Views: 10
|
Feed a wire coat hanger that is straightened out through the hole that also has the Hood Release cable. I prefer white coat han
Date: 04/12/2004
Views: 8
|
Once the coat hanger is through you will be able to see it down below about a foot deep. (very hard to see but it's that white
Date: 04/12/2004
Views: 10
|
|
Slightly better angle, with view of the Master Cylinder for reference point.
Date: 04/12/2004
Views: 9
|
Pull your wires through to the cockpit of the car.
Date: 04/12/2004
Views: 10
|
Strip and Crimp on another Male and Female wire connector and plug 'em in.
Date: 04/12/2004
Views: 9
|
